Five Cases in the Selection of CNC Cutting Machine

First, cutting accuracy
For the construction industry, the general cutting requirement is less than 0.5mm; the requirement on the car mirror is less than 0.01mm and the cutting thick of steel plate should be as thin as possible. Now the cutting accuracy provided by various machinery manufacturers is generally less than 0. 2mm, but it cannot be judged by the introduction of the product manual, and there should be a complete set of test procedures to test the cutting accuracy in the acceptance, to measure the actual cutting accuracy, we generally have a dozen test sample surfaces. We can completely control the flatness of the cutting platform, control system and the synchronization level and crimping machine according to the test.

cutting machine

Second, the cutting speed
We cannot talk about the speed until we can meet the cutting precision, due to the cutting platform is short, it is difficult to judge whether it is the highest speed with eyes. So we can take advantage of the cutting machine servo drive with software simulation function to see whether the speed of the motor is at the highest speed. Each axis can be tested separately, but also can be tested simultaneously.

Third, the automation of cutting machine
At the edge of the CNC cutting machine, considering processing costs and the special types of volumes chip, which requires the operation of cutting machine is simple, easy to understand and not too complicated, otherwise it will cause the embarrassing situation that we can afford the machine but cannot feed the machine, such as bending machines for sale. So the manufacturers should make some researches to find out the easy and high-efficient operation mode.

Fourth, easy maintenance
The signal and the mechanical sensors are unnecessary to be equipped to much, and the switches and indicator lights should be as less as possible, because the fault in a mechanical device will affect the use of the cutting machine, and the fewer parts will bring low probability of fault, in addition, the small number of lines is convenient to find fault and replace the parts, so it is the best that will be able to debug the I / 0 signal state on the screen. The maintenance cost is a important factor that should be considered in the purchase of machinery.

Fifth, save energy
We should select the cutting machine with less energy consumption when they can complete the requirements of the same cutting size, and which will bring many benefits to the enterprise. First, protect the environment, save energy; second, save the daily expenses. is an integrative enterprise of R&D, production and management. It is a director unit of China Building Metals Construction Association of Ministry of Construction and became the profession standard drafter of national aluminum processing in June,1998. Furthermore, its product have gained the honor of "Chinese Famous Product".

Chat Online 编辑模式下无法使用
Chat Online inputting...